Search This Blog

Thursday, November 15, 2012

My new favorite low cost geek tool



Being in IT, I am constantly dealing with hard drives, data, moving data, moving drives, etc. and my team is always dealing with these issues as well.

We had a situation come up where we needed to build a new drive in a laptop and the user had a lot of data to move.  The original drive was still good.  The problem with it being a laptop is there obviously isn't room for the second drive.

Amazon is my friend.  I have a prime account and I'm sure, much to the dismay of the CDRW or PCMall rep; I buy the majority of our company IT supplies from Amazon; it's cheaper and Prime gives me free shipping.  A little searching on Amazon and I found a Cables To Go 30504 USB 2.0 IDE or Serial ATA drive adapter kit for $22.05.

This is the best $22 I've spent on an IT tool this year.  It's saved us lots of time in transferring data!  Since we bought it we have used it on both IDE and Serial ATA drives without any problems.  I've tested it on both mac and pc with several different major brands of drives.

Like most IT Departments, mine has been around for a long time and thus we have a large collection of old hard drives sitting around waiting to be examined, wiped, destroyed and recycled.  Many of these drives pre-date me and likely have nothing on them of importance.  That doesn't mean we would throw them out without looking first! 

You will receive a 5-inch 7-pin M/M serial ATA Cable, a power supply for both SATA power and 4-pin Molex power, and a page of concise, clear instructions on how to use the device.  The setup requires no additional software to use it.

Another great use for this device is it allows you to turn those old drives into USB storage devices so if you're hard up for space, grab and old drive and go!

At $22 this thing is worth ordering just to have it sitting and waiting for that critical time you need it.

Stacking PowerConnect 6248p Switches When They Both Come Up as Master

We received two new Dell PowerConnect 6248p switches from Dell this week.  In installed two 10gbe stacking units with the switches and cross connected them.  I was surprised when I powered them up (the one I hooked my console cable into was booted first) that they both came up as masters and they went into a strange loop of booting operational mode over and over.

I shut them down and booted up just the one switch.  It was in the loop still and so I went ahead and reset it to the factory settings.  Upon reboot it presented me with the wizard option to setup the switch and allowed me to go through the config.  I did a factory reset on the other switch as well but they still would not stack.

To get them to stack I had to perform the following on both switches, then reboot them both.

If you've not configured switches before everything after the # is what you type for the command so only type what is in bold below

en (enables the console)
console#show stack-port
console#config
console(config)#stack
console(config-stack)#stack-port 1/xg1 stack
console(config-stack)#stack-port 1/xg2 stack
console(config-stack)#exit
console(config)#exit
console#copy run start

I then rebooted both switches and the one I rebooted first came up as the master.  This probably took it about a 5 minute cycle to configure them and reboot them both.  Now they are a stacked switch.

If you go back to your console again (hooked up to the switch with the Master led lit up you can again go to show stack-port and it should now show them as Stack instead of Ethernet and Link Up as the status.